FI70 3 axis page not showing (fixed thanks Johnny)
- Thread starter hori
- Start date
What version of software is in the FI70?
1.11 is the newest and includes the 3 axis screen but you must select and configure the display to the screens you want. Unless the box got marked but the unit never got upgraded; you should be able to configure the 3 axis screen as on of your many options.
https://www.furunousa.com/-/media/sites ... hanges.pdf
I am assuming the photo you posted showing the 3 axis speed is someone else's and not yours.
https://www.furunousa.com/-/media/sites ... hanges.pdf
I am assuming the photo you posted showing the 3 axis speed is someone else's and not yours.
I checked today and went into system settings, Data source and the 3 axis is showing along with heave and everything else that SCX20 outputs. When I go to set up a page to display the 3 axis it is not in the speed category. Having the 3 axis display was one of the deciding factors to buy the FI70.
anything else I should be looking at? The system is set to sub, Ais works, heave , speed, heading and so on.
anything else I should be looking at? The system is set to sub, Ais works, heave , speed, heading and so on.
Why do you have it set as a sub?
Please double check your software by going to System - Diagnostics - Selftest and ensure you have 1.11.
Please double check your software by going to System - Diagnostics - Selftest and ensure you have 1.11.
It should be setup for stand alone in the settings unless you have good reason to do otherwise.
OK, so I set to stand alone, did the Diagnostics, Self test, and then went back to set up page and FINALLY 3 axis was available for display data. I assume because I had it set to sub it wasn`t showing? anyway all good, working well and thank you again for getting me sorted out, cheers :furuno
Good to know for me as well. Thanks for asking about it.
Similar threads
