FCV 1150 & R209 Transducer

[42Duffy]

Snips
I was reading an old post where you mentioned a document you wrote about configuring the unit to compare 2 low frequencies. In that post you referenced that the document was under technical documents for the CA82B-35R. I can’t find it there. How can I find a copy?
I canyon fish out to 3500 feet and have good bottom image. It would be nice to compare on dual mode 33 and say 45 kHz

What changes when SQUID mode is selected? What frequencies are better for seeing squid?
Any other suggestions if I am trying to see squid in the water column?
Thanks

 

[Snips]

Duffy42,
That document only works for the CA82. However, look at the Frequency Choice/Control section in the operators manual. It describes how program the sounder for preset frequencies. You won't be able to do 33/45Khz, but if you start by programming the LH side for 44Khz with a band width of 22Khz you should be able to add another preset at 33khz.

Snips