FAP 7002 exit SIM mode

[Dagomoyac]

Good, the pilot was put in simulation mode and the only thing he does is change only the screens making it impossible to use it if someone was so kind to tell me how I can get out of that mode or how to completely restart the same
very grateful for the help

Dagoberto Moya C
Costa Rica

 

[Johnny Electron]

If placed into simulation, one would only have to power the display OFF and back ON to exit SIM mode. If the unit is going into sim mode by itself, it would be because someone has mixed old software with new, or the communication bus has a problem between the display and processor. Most common is someone has a mix of old and new software between the processor and display. I would start by upgrading both the processor and display to new software. If the wiring is incorrect or the bus termination isn't on the back of the controller can also cause this problem. The display controller should be wired to the pilot processor properly and not to the NMEA 2000 bus.

 

[Dagomoyac]

Thanks for the response, but still in simulation you can tell me how I do the software update

 

[Dagomoyac]

Thank you very much, it was solved by updating the units
very thankful
Pura Vida