Dual Transponders with a TZT3 12F

[Ironworker]

I have a B175HW and a B175L Airmar Transducers (with mix and match cables) on my boat coupled with a TZT3 12F. I want to run both transducers with out manually switching cables. I was told that Airmar makes a cable that combines the two transducers which I ordered but it does not fit the "mix and match cables" or the adapters that came with the TZT3 12F.

Before I order another cable, I thought I would ask this group if there is a better solution that the combo cable?

 

[TheReaper]

That combination of transducers is approved/compatible with the TZT12F. Assuming that the B175HW and B175L both have 10-pin Furuno connectors on the end of their mix-and-match cables, the cable you need is AIR-040-406-10. This cable is a y-cable that has a single 12-pin connection (for the TZT12F) going to two 10-pin connections (for your transducers).

 

[Ironworker]

Thanks. I appreciate the response

 

[Ironworker]

For others that may be checking this thread out, apparently the Airmar B175L requires a different cable that the HM transducers. According to airmar the B175HW requires a #MMC-10F-HM and the B175L requires #MMC-10f-L. These are the Mix and match cables that will go to the Y cable that I posted in the OP.

What I am trying to determine whether the original M&M cables (MMC-12F-FU) were correct for the B175L as I cannot get that Transducer to work with the TZT3 12F. Standby for the answer.

 

[Ironworker]

Airmar verified that the B175L transducer DOES require a different mix and match cable. So if you are trying to connect two transducers make sure you are sold the right stuff.