Connect 711c navpilot to Zeus3s b&g plotter

[Joan]

Hello,

We are the lucky owners of a Furuno 711c navpilot with PG700 compass. In addition we have a B&G H3000 CPU with a Zeus3s plotter. The PG compass is showing up in the Zeus3s just fine and we are using it for heading data.

In the 711c I have configured the wind data source comming via NMEA / H3000 / Zeus3s.

The Zeus3s has a possibility to control the autopilot. I tried to configure the Zeus3s and connect the Furuno 711c but it doesn't show up...

Can somebody tell me if it is possible to connect the 711c with the Zeus3s? And if so how can I do this?

Kind regards,

Joan

SV Caconano
Amel A55

 

[Johnny Electron]

If using 0183 data, ensure you are providing the pilot APB, GGA, VTG, RMB, RMC and XTE.
Then go into the pilot and select that NMEA 0183 port for which the plotter is wired as your "NavSource"