Blue target trails no working on 2nd TZT3.

[allrelative]

I added a 2nd TZT3, connected it to NMEA backbone and to network hub.

The radar is directly connected to TZT3 (primary unit). The primary unit is also connected to the hub. The radar works from both units except for the blue trails are missing on the newly added TZT3. ALL of the settings under the radar settings, Trails are identical.
Any ideas? this is sitting at the dock, but you can see the lack of blue. Tried turning off and switching colors, did not work.

Thanks

 

[Johnny Electron]

Does both of the TZT3 units have 2000 cables connected? It is almost like the second MFD isn't seeing the needed heading for trails.

 

[allrelative]

Yes, the NMEA is connected, and both are getting the heading from the SCX20. The heading green line is also present on both screenshots. Since this is new and the install was so easy, I was considering resetting the new one. Not sure at this point.
Thanks for looking at this !

 

[Johnny Electron]

Make sure both the TZT3 units are at the same software version. You might also check your radar color setup and compare the two. Maybe the one is showing the echo trails but the color is black; blending into the background.

 

[allrelative]

Thanks, I tried changing the colors on both several times, No luck. I might try the factory reset on the unit next.