Autopilot speed detection not available

[tunaluvr]

I have this error message on my autopilot screen. My heading sensor is working but I dont know how to get this off or how to fix this.

 

[Mr. Limpet]

Which NAVpilot model are you using?
Have you configured the pilot "sensor setup" to look at that source under SOG (speed over ground) setting?

 

[tunaluvr]

Which NAVpilot model are you using?
Have you configured the pilot "sensor setup" to look at that source under SOG (speed over ground) setting?

I have the 711C autopilot and the PG 700 heading sensor with a TZT 12 and TZ14
I havent looking into the sensor set up. Is that on the 711C or on the TZT 12 settings?

 

[Mr. Limpet]

It is a screen in the 711C. You will need to select your GPS source as the source of speed (SOG) in that screen.

See section 3.8 in the Installation Manual. I have provided a link below (for your convenience):

https://www.furunousa.com/-/media/sites/furuno/document_library/documents/manuals/public_manuals/navpilot700_711c_720_installation_manual.pdf

 

[tunaluvr]

It is a screen in the 711C. You will need to select your GPS source as the source of speed (SOG) in that screen.

See section 3.8 in the Installation Manual. I have provided a link below (for your convenience):

https://www.furunousa.com/-/media/sites/furuno/document_library/documents/manuals/public_manuals/navpilot700_711c_720_installation_manual.pdf

Awesome, thank you. I:ll try to work on it today and see if this works. If not i"ll be back with more questions. LOL. Thank you