Hello:
I purchased a boat that came with an Octopus pump and, I’m assuming, an Octopus hydraulic linear actuator. It was connected to an old Furuno 3002 processor. It also came with the parts for a 711 auto pilot( not installed), 7002 processor,RRU, 711 controller, and PG-700 heading sensor. After looking at the pump, I am confused about how to connect the pumps wires to the processor.
What wire is what and where to connect it. I have the Furuno manual but I am still unclear. I can’t seem to find what I need from the Octopus website too. Any help will be great.
Thank you
Mark
I purchased a boat that came with an Octopus pump and, I’m assuming, an Octopus hydraulic linear actuator. It was connected to an old Furuno 3002 processor. It also came with the parts for a 711 auto pilot( not installed), 7002 processor,RRU, 711 controller, and PG-700 heading sensor. After looking at the pump, I am confused about how to connect the pumps wires to the processor.
What wire is what and where to connect it. I have the Furuno manual but I am still unclear. I can’t seem to find what I need from the Octopus website too. Any help will be great.
Thank you
Mark