Adapter for TZT3 16” and B265LM

[Cabo92]

Which adapter do I need to connect a Airmar B265LM and the TZT3? Thanks !

 

[Magnetron]

The TZ3 supports this transducer. If it doesn't have a connector, than you could purchase transducer pigtail, 10-Pin(F) and attach it to the leads of the transducer and then plug the assy. into the 10p-12p adapter for the TZ3. Otherwise, if it has a connector (such as Raymarine) you can order a mix-and-match cable from any Furuno/Airmar dealer.

ref. https://furunousa.com/en/products/air-033-333

- Maggy

 

[Johnny Electron]

Ideally, like Magnetron alluded to, it would be purchased with the correct 12 pin connector already on it. (B265LH-12P) If the version designed for the DFF1-UHD is purchased, then you would need to adapt it to the sounder using a 12 pin pigtail. I don't suggest following the method Magnetron suggested because you will not have enough connections for the wires to a 10 pin. If done, you should go directly to the 12 pin using the pigtail. (TZ3-12P-PGT)

 

[Cabo92]

The end of the 265 plugs right into the back of the unit using the extender it came with, that’s for the advice

 

[Magnetron]

The end of the 265 plugs right into the back of the unit using the extender it came with, that’s for the advice

Awesome! :jump :jump

- Maggy