6.03 and Marine Zones/Tides Update

[buefin039]

I just purchased a TZT14 and I updated the software from 5.01 right to 6.03. I did the full software update. Then I went to do the marine zone and tides update, but the instructions said it was for versions 6.02 and lower.

Was that instructions page written before 6.03 came out and I should do it? OR did 6.03 have its own updates for marine zone and tides that superseded that one?

I assume the instructions page is just outdated, but wanted to wait to get confirmation.

Thanks

Pete

 

[Johnny Electron]

You are correct. The instructions were written before 6.03. I think 6.03 should already load the new zones but it can't hurt anything to load them again just to make sure.