TZT2 v8 wifi not seeing network

Hi! Longtime lurker, first time poster. I upgraded to v8 from v7 last week. Update went well without any difficulties. The problem I have now is that my wifi network doesn't show up on a "scan". There were no difficulties with this network prior to the upgrade. The network does appear, though, in ServiceMan under the WLAN tab. See attached screenshots of the TZT setup screen and the ServiceMan WLAN. The network is "Pepwave_67A2".

Any ideas welcome!

(sorry, I guess I don't have enough posts to upload photos)

Hi,

Did you master reset the unit after doing the V8 update?

Here is the master reset instructions just in case you may of missed that step.
https://furunousa.com/-/media/sites...re/software/tzt2_factory_reset_procedures.pdf

This may be elementary since you seem to know how to setup the WiFi... but... :?

Is the Wireless Mode set to Create Local Network?
It the Local Network enabled (On/Off)?
Does it show the Local Network Settings in the WIRELESS LAN SETTINGS page?

Hi all! Thanks for your replies. Yes, I have done a Master Reset. I have not set it to "Create Local Network", for the reason stated. I did see something from back in 2017 or so where another forum user had a problem with special characters in the SSID. My SSID has an underscore (which did work fine in v.7 2 weeks ago, but hey...). I'll try renaming the SSID without any special characters and report back. Any other ideas, please feel free to keep them coming. Thanks again!!