Hello
I am having an issue where I don't know if I am properly understanding how to adjust the range and shift on the right side of the sounder window (which is normally the full size side) when I am in "bottom zoom" mode.
My normal configuration is "bottom zoom" and manual range and gain. The full size / non bottom zoom display is the right half of the screen. The bottom zoom display is the left half of the screen
What i have noticed is that no matter what i tap or touch or turn on the roto-key, all it does is adjust how zoomed in the left half of the screen is. I can't seem to get it to adjust the way I want.
What am I doing wrong? I have tried tapping, swiping, pinching, and the roto key. It all seems to only adjust the bottom zoom side of things.
Is there any TZT3 internal sounder video that gets into stuff like that?
I have the manual, and it explains how to do manual range selection as well as how to shift the display range, and this works when in single frequency display without any zoom. However, it seems like I cannot adjust it once the zoom is enabled.
I'm wondering if marker zoom is a better way to go, or perhaps dual frequency,, where i have 50khz showing the full water column and 200khz zoomed in...
I am having an issue where I don't know if I am properly understanding how to adjust the range and shift on the right side of the sounder window (which is normally the full size side) when I am in "bottom zoom" mode.
My normal configuration is "bottom zoom" and manual range and gain. The full size / non bottom zoom display is the right half of the screen. The bottom zoom display is the left half of the screen
What i have noticed is that no matter what i tap or touch or turn on the roto-key, all it does is adjust how zoomed in the left half of the screen is. I can't seem to get it to adjust the way I want.
What am I doing wrong? I have tried tapping, swiping, pinching, and the roto key. It all seems to only adjust the bottom zoom side of things.
Is there any TZT3 internal sounder video that gets into stuff like that?
I have the manual, and it explains how to do manual range selection as well as how to shift the display range, and this works when in single frequency display without any zoom. However, it seems like I cannot adjust it once the zoom is enabled.
I'm wondering if marker zoom is a better way to go, or perhaps dual frequency,, where i have 50khz showing the full water column and 200khz zoomed in...