The current RD-33 Manual (version E downloaded from the Furuno site) shows the page I have attached. On the RD-33, it should be found at Menu>I/O/>SetUp>Data Source.
My RD-33 does not show the sentence I have highlighted (NMEA 0183 Output Mode....).
Is this a firmware issue (mine is v01.06) or is there something elsewhere that I need to turn on to bring this up?
( I am hoping to use my RD33 to convert autopilot nav info PGN's (129-283/+284) from my TZT14 to 0183 for my older autopilot, so I don't also need to buy an IF-NMEA2 translator. Please let me know if this is not feasible, irrespective of firmware issues!)
thanks
My RD-33 does not show the sentence I have highlighted (NMEA 0183 Output Mode....).
Is this a firmware issue (mine is v01.06) or is there something elsewhere that I need to turn on to bring this up?
( I am hoping to use my RD33 to convert autopilot nav info PGN's (129-283/+284) from my TZT14 to 0183 for my older autopilot, so I don't also need to buy an IF-NMEA2 translator. Please let me know if this is not feasible, irrespective of firmware issues!)
thanks