Hi,
I bought Navpilot 300 2 weeks ago with the octopus pump.
I did all the hardware installation
Am doing the programming or the setup of the system.
Whenever I reach the Air bleeding step, I follow the instructions , when I press the button to move the rudder is gives me “drive unit overloaded check drive circuit,
Any suggestion on what should I do?
Is the processor needs any repair?
Thx in advance
I bought Navpilot 300 2 weeks ago with the octopus pump.
I did all the hardware installation
Am doing the programming or the setup of the system.
Whenever I reach the Air bleeding step, I follow the instructions , when I press the button to move the rudder is gives me “drive unit overloaded check drive circuit,
Any suggestion on what should I do?
Is the processor needs any repair?
Thx in advance