On one of my two TZT2s a blue Nav Data display appeared in the place where normally the status bar is displayed, showing DTA,TTA,ETA and SOG but with no content except a SOG of 7kts, while the boat was still moored. See screenshot.
I cannot reproduce it, going through what I think the steps were before this bar showed up.
Steps were:
(1) Only one TZT2 on, Radar without power.
(2) Imported two routes via USB stick.
(3) Clicked on the start point of one route to see it.
(4) selected 'Start Nav' from the right side panel.
(Not sure the strange nav bar appeared at that point, I noticed it a bit later).
(5) powered up radar and second display.
(6) checked that route was shown active on second display and it was.
(7) noticed the unusual bar on the first display.
(8) the unusual bar disappeared when we reached the end of the route.
Whatever I tried, I cannot get this to reoccur.
Any thoughts?
I cannot reproduce it, going through what I think the steps were before this bar showed up.
Steps were:
(1) Only one TZT2 on, Radar without power.
(2) Imported two routes via USB stick.
(3) Clicked on the start point of one route to see it.
(4) selected 'Start Nav' from the right side panel.
(Not sure the strange nav bar appeared at that point, I noticed it a bit later).
(5) powered up radar and second display.
(6) checked that route was shown active on second display and it was.
(7) noticed the unusual bar on the first display.
(8) the unusual bar disappeared when we reached the end of the route.
Whatever I tried, I cannot get this to reoccur.
Any thoughts?