Power.Boater
New member
Hi,
We are upgrading the electronics on our Cabo 40 by installing 3 TZT2 12's. We have removed the original 2006 vintage multiducer, replacing it with a Furuno (B60) 525T-LTD/20. We would like to also integrate the existing 2KW internally mounted transducer. We are not at this time installing a standalone sounder module. The install guide and manual doesn't address this configuration so I am hoping one of Furuno's experts might provide tips and suggestions regarding how best to connect the two transducers into the system we are building. Do we pair each transducer to one of the the TZT2 -12 MFD's? Is there an interface device to which we should connect both transducers and then connect the interface to the network?
Your thoughts are appreciated and welcome?
Greg Lee
Huntington Beach, CA
We are upgrading the electronics on our Cabo 40 by installing 3 TZT2 12's. We have removed the original 2006 vintage multiducer, replacing it with a Furuno (B60) 525T-LTD/20. We would like to also integrate the existing 2KW internally mounted transducer. We are not at this time installing a standalone sounder module. The install guide and manual doesn't address this configuration so I am hoping one of Furuno's experts might provide tips and suggestions regarding how best to connect the two transducers into the system we are building. Do we pair each transducer to one of the the TZT2 -12 MFD's? Is there an interface device to which we should connect both transducers and then connect the interface to the network?
Your thoughts are appreciated and welcome?
Greg Lee
Huntington Beach, CA