possible update issue

[buckshot]

I noticed yesterday that if I tried to change my chirp sidescan range from auto to manual that it also changed my DFF3d. I could not change one without the other being changed also.
I usually run the side scan offshore in manual so I only see about 200-300 feet to the side but I keep the DFF3d set at auto depth range.

 

[buckshot]

any feedback?

 

[gtstang462002]

Interesting, I haven't come across this issue with my setup. There are times where I am looking at the same setting, 2-300ft out with the sides can, but my DFF3D stays in the auto ranging mode. This is when I am in the river, so I am looking at 50-100ft of actual depth and my 3D reflects what I would expect it to do in those depths.

 

[buckshot]

Figured it out, The side scan chirp was having connection issues and the TZT3 switched to side scan view from the DFF3d. I thought I was looking at the chirp but it was the side scan view from the DFF3d. I fixed the connection issues and now I have side scan chirp and I can pick auto on the DFF3d and manual on the chirp side scan.