I just installed a PG-700 into my TZT-2 MFD that is connected to a transducer, DFF3D, no radar.
Do I have to tell the TXT2 that it should now take Heading Data from the PG-700 or does that "automatically" happen.
Basically, after I go through the calibration procedures outlined in the PG-700 manual, do I have to do anything to the MFD, I could not find anything in the TZT2 manual.
Do I have to tell the TXT2 that it should now take Heading Data from the PG-700 or does that "automatically" happen.
Basically, after I go through the calibration procedures outlined in the PG-700 manual, do I have to do anything to the MFD, I could not find anything in the TZT2 manual.