Need part # for Mix&Match cable

I

Indyspecracer

Member
Due to the extreme shortage of transducers, I ordered a non-diplexed B260( 526tid-hdn). This ducer will be used with a 12” TZT3.
I know that I will need a Diplex-MM, but there seem to be many 10 pin M&M cables. Some of the descriptions mention high and medium frequency, some mention high CHIRP, etc.
Can you guys guide me to the correct part number for the cable? Not sure on length, but 6 to 8ft should be plenty. Thanks
 
Mix and match transducers are an exclusive product of Gemeco so it would be best to contact them about your needs. The B260 is an excellent transducer and one of my all around favorites. While on smaller boats it will need to be flushed into the hull, larger 30ft and bigger can use the included high speed fairing.
 
You must log in or register to reply here.
Back
Top