I have a navnet mfdbb mPu-001. It's going into installation wizard and nothing, control pad isn't doing anything, haven't tried sync yet. If sync fails, then go to wired keyboard?if that fails Master shutdown, power and cancel on the keypad or is that only mfd12? Say all else fails can I take an mfd12 and use it in place of my mfdbb, is there a control module for mfd12 or its in the screen? Will it communicate with other furuno devices
Mfdbb replace with mfd12?
- Thread starter Amcd92
- Start date
It goes into the wizard, you should be able to use a USB mouse to set the DHCP server setting to ON and SAVE and EXIT. This will allow it to give the keyboard an IP address then you should be able to sync it and work from there. If you can use an MFD12 is a bit open because I don't know what radar is being powered by the MFDBB etc. Do you have a drawing of the system?
