Wdeertz
Furuno Fan
While underway today in a shallow area with a silty bottom I lost my depth reading from the Airmar DST200 n2k sensor. Nothing unusual here given the silty bottom the sensor wasn’t getting a signal bounced back. After a short while the DST200 started reporting the depth again which I could see on my RD33 screen, however my TZTBBX and TZT2BB both continued to show no depth reading (“- -“). I went into the settings screen on both the TZTBBX and TZT2BB data sources and the DST200 wasn’t showing as being available. I know the DST200 was putting data on the n2k network as it was showing a proper depth on the RD33 screen. I tried rebooting both TZTBBX/TZT2BB and the depth still didn’t show up. Only after I rebooted the entire n2k network did the DST200 show up again on TZTBBX/TZT2BB.
Is this normal behavior for both of these devices to not recognize n2k sensors that reappear on the network?
Is this normal behavior for both of these devices to not recognize n2k sensors that reappear on the network?
