TZtouch3 units have recently shipped from Furuno USA with v2.03 software. These MFDs can be mixed with existing 2.01 units without impact. This minor version change provides no noticeable difference, but was necessary to support a needed production change.
These new units cannot be downgraded to v2.01, so if you are installing a new TZtouch3 MFD into an existing TZtouch3 network, all MFDs on that network must be updated to v2.05.
Most v2.01/2.03 users have little reason to upgrade to v2.05 unless adding one of these newer MFDs to their existing network. This is a minor update so if it isn't broken; don't fix it.
The full TZT3 software history can be found at the following link.
https://www.furunousa.com/-/media/sites ... istory.pdf
Software, software history, and complete software update information can be found under the "software" tab of the TZtouch3 product pages. A pre-programmed software update kit is also available from Furuno USA dealers for a nominal fee. Part number TZ3-SOF-USB
These new units cannot be downgraded to v2.01, so if you are installing a new TZtouch3 MFD into an existing TZtouch3 network, all MFDs on that network must be updated to v2.05.
Most v2.01/2.03 users have little reason to upgrade to v2.05 unless adding one of these newer MFDs to their existing network. This is a minor update so if it isn't broken; don't fix it.
The full TZT3 software history can be found at the following link.
https://www.furunousa.com/-/media/sites ... istory.pdf
Software, software history, and complete software update information can be found under the "software" tab of the TZtouch3 product pages. A pre-programmed software update kit is also available from Furuno USA dealers for a nominal fee. Part number TZ3-SOF-USB
