FURUNO HF/MF AT1560-25 & FS-1550

Status
Not open for further replies.

danielgarci92

New member
Good morning

I have the FS 1550 transmitter AND the AT 1560-25 coupler, which is more modern than the transmitter.

When I connect the control cables, I can't get the transmitter to receive the tune OK, so it doesn't transmit with full power.

The coupler starts the impedance selection sequence, and finishes it normally fast. It stops, the transmitter gives error and the relays return to their original state, I understand because the transmitter sends the signal through.

Does anyone know what this could be due to? Does anyone know how I should connect it or which is the communication protocol, or if they are the same, or how to adapt it?

Thanks
 
Status
Not open for further replies.
Back
Top