Dff1uhd and 2 transducers

A

Anonymous

Guest
I have installed a dff1uhd with a pm275w transducer. My display is a md3d 12 inch unit, my question is can I run the high frequency wires of the 275w and a high frequency 175 to the two sides a double pole (on off on) toggle switch, then run the output to the dff1uhd? The reason is I would like to use wide high transducer for scanning and the narrow transducer for better bottom reading and fish detection. If I can what special requirements need to be meet?

Thanks John
 
Jabcon,
I don't see a problem doing that. Make sure the shield wires are all tied together.

Snips
 
Back
Top