Couple XL questions

[Saltybrad]

I have a couple things I would like some further help with.
1. Can the slide out data bars be set up with different information screen dependent?
2. I would like my Icom VHF display the AIS targets on my MFD. Is that possible like older Garmin and Simrad units did?
3.Display individual gas tank and motor burn. I would like to keep track of the port and starboard tank levels separately with the manual refill utility.
4.Suppprt for the DFF1 paired to the B175HW with auto transducer identification.
5. When I push and hold a spot on the sounder screen I would like the option to create a way point as well as possibly an event.

Is there a way to further these utilities on the existing operating system. Loving the Furuno performance just want to customize a bit for my use.

 

[FishTech]

1. Yes. At the top of the boxes you will see "Data" and something else. Data is common across all pages. The other one is for the relevant pages and different on each one. Route for the plotter, Radar for the Radar, etc.
2. Yes, we can display the AIS targets from the Icom if it is configured properly to output them.
3. What do you have for tank senders and fuel flow sensors?
4. The DFF1 does not do CHIRP. The DFF1-UHD can do CHIRP. The B175 transducers are not officially supported but many user have reported great results while using them. If you use a B175 on the DFF1-UHD you cannot use TDID and you must install a specific resistor on the unused channel.
5. You can have this happen with a two finger tap or a two finger long long tap. It's one of the first options in the General menu.