Check Engine Alarm w/ TZT10X & TZT16X

S

sails&tales

New member
I have had the 10X and 16X installed at the helm for a few months (roughly 200+ hours of runtime) and they've been working flawlessly, other than a SCX20 & radar interference issue. Boat is powered by twin Mercury Verados with a Vesselview engine management computer. Over the weekend both units triggered a Check Engine Alarm and when I looked further I found that the MFDs were getting engine data for the Starboard motor but no data from the Port motor.

Motors were running fine and Vesselview continued to display all engine data for both motors.

Any ideas why the Furuno units are no longer displaying/recognizing the port motor data?
 
Try running the engine and tank setup again. HOME - SETTINGS - INITIAL SETUP - INSTRUMENT SETUP - ENGINE AND TANK AUTOMATIC SETUP
 
You must log in or register to reply here.
Back
Top