AIS target not displaying

J

jacksparx

New member
System:TZT2BB, HUB 101,AIS 170, SC33, IF-NMEA2K2
Scenario. TZT2BB working well, showing SC33 data via CAN buss
FA170 showing targets, good comms test on its own monitor. CAN bus data into AIS via IF on sensor 2, purple line not cut as sensors run at 4800B show up on monitor.
BUT, no AIS targets on TZT2BB monitor, (yes AIS targets enabled on settings and edge swipe, thanks for asking).
New install. What am i doing wrong?
Thanks,
 
helo jacksparx,
can I try to explain again?
1. if you using IF-NMEA2K2, be sure to use line Green(RD-H) & Yellow(RD-C) to AIS FA-170
2. in FA-170, have "LAN port" in Transponder AIS. have you tried it?

Thanks
 
You must log in or register to reply here.
Back
Top