Connecting a Furuno CA200B-5 to a Furuno FCV 292

A

Anonymous

Guest
Im trying to connect My Furuno FCV 292 to a Furuno CA200B-5 Transducer, My FCV292 has the 50 and 200 Plugs connected to one cable and the Furuno CA200B-5 has one cable, Im not sure what color wires go where..
 
Munchkion,
Does your transducer cable have one five pin plug and then splits into two cables each with four pin plugs? If so, one of the four pin plugs goes to the HF (200Khz) and the other goes to the LF (50Khz) side. The HF and LF should be marked on the back of the sounder. You have two options, first you buy a new four pin connector or you can try to reuse one. Either way the red wire goes to pin two, the black to pin four and the shield to pin three. Hope this helps.

Snips
 
Back
Top