Sdpaddler50
Member
I am not doing the installation, but I am personally buying the gear.
45 ft., single engine, Recreational Trawler that will travel up and down the Cal Coast. Very limited fishing, so the main goal is a solid system for day and night time offshore running.
Two helm stations (upper and lower), with one NavNet TZ at each station, and AP capability at each helm.
The Furono System Builder is calling out the following in the chart below. Instead of the open array, I will be going with the DRS4D-NXT dome. I have purchased a different Xducer (Furono Airmar Bronze) than is shown.
Note: I posted this same info on a different website, but I am not getting feedback to my questions, so I have reposted it here hoping people with Furono experience can help.
My next post will have the questions..
45 ft., single engine, Recreational Trawler that will travel up and down the Cal Coast. Very limited fishing, so the main goal is a solid system for day and night time offshore running.
Two helm stations (upper and lower), with one NavNet TZ at each station, and AP capability at each helm.
The Furono System Builder is calling out the following in the chart below. Instead of the open array, I will be going with the DRS4D-NXT dome. I have purchased a different Xducer (Furono Airmar Bronze) than is shown.
Note: I posted this same info on a different website, but I am not getting feedback to my questions, so I have reposted it here hoping people with Furono experience can help.
My next post will have the questions..