Connect Furuno DFF1 at airmar B258 Blue Connector Lowrance

oltremare2003

New member
Good morning,
I introduce myself, my name is Rino and I am rookie to the site and I would like to ask a little help. On my boat I have an Airmar B258 transducer with a Lowrance blue connector. What could be the best way to connect it to the DFF1 module of my Navnet Vx2 system?
I thank you in advance for your patience and bad English me.
 
Can you provide the full part numbers from the transducer? It will most likely work if you cut off the connector and wire on the Furuno 10 pin pigtail cable (p/n AIR-033-333). We should check the part number to be sure.
 
Thank you for reply Johnny,

at the moment it is impossible for me to find the exact code of the transducer B258 Airmar. However the Furuno cable should have 10 wires while the Lowrance cable 7. How should I connect them?

Thank you.

Rino
 
If the transducer is made by Airmar, the internal color code of wiring should be the same. Without you able to provide any numbers off the unit, I can't verify that for sure.
 
Back
Top