Page 1 of 1

MFD12 Calibration Settings

PostPosted: Tue Jun 27, 2017 8:38 am
by s4rs
I was going through the calibration settings on my MFD12 and wanted to set the Draft Depth. My question is do you set the draft as a positive or negative number? IE I have a 2' draft do I set this as -2' in the general settings or a +2'?? My mind says -2' since the hull is under water and the surface is 2' above..

Re: MFD12 Calibration Settings

PostPosted: Fri Jun 30, 2017 5:16 pm
by Johnny Electron
Yes it can go negative. Please see below from the Operator's Manual.
Capture.JPG