Replacing VX2 RDP149 with 12" TZTOUCH 2

T

TeamRezoned

Guest
Good afternoon,

We are planning to replace our NavNet VX2 with a TZTOUCH 2 12" display. I have searched online and cannot find the mounting hole dimensions for the VX 2 vs the TZTOUCH 2. I am wondering if we will be able to use the same hole or if we will have to have a new dash panel made. Unfortunately the boat is at the coast and I can't measure the hole myself.

Could one of you fine gentlemen assist by providing the mounting hole dimensions for each of these units?

Thanks,

Dan
 
Also note that Furuno offers a retrofit panel that allows you to put a TZTL12F right into the same cutout that a Vx2 used to be. You might talk to your dealer about it.
 
Thank you both for the information. This Forum and Furuno's customer service is a huge part of why we are sticking with Furuno.

Do you happen to have a part number for that Furuno panel?

Thanks!
 
Thanks to all for the replies. I have pulled the trigger on the TZT4 and 4D radar. I will be working on installation in the next few weeks and will likely have some questions at that time.

- Dan
 
Back
Top