A
Anonymous
Guest
Hello,
I am new to this forum but just have a question regarding my Furuno FI50 instruments. Yesterday I did the yearly software update of my MFD8 through mynavnet. The current version is 2.07. During the update process the system showed that the FI50 instruments will also be upgraded with a newer version. After upgrading and hitting OK on the MFD 8 the system shutted down. After rebooting, the instruments do no more show any value. In fact, every segment of the instruments is highlighted now. I cannot switch them of or change any settings at the FI50. There are three instruments, two multi and one wind, that behave exactly the same. I tried to run the firmware update again but the screen of the plotter no more shows the FI50 instruments. I have added a screenshot to better show how the instruments look after the upgrade.
Does anybody know how to fix the problem?
Best regards Axel
I am new to this forum but just have a question regarding my Furuno FI50 instruments. Yesterday I did the yearly software update of my MFD8 through mynavnet. The current version is 2.07. During the update process the system showed that the FI50 instruments will also be upgraded with a newer version. After upgrading and hitting OK on the MFD 8 the system shutted down. After rebooting, the instruments do no more show any value. In fact, every segment of the instruments is highlighted now. I cannot switch them of or change any settings at the FI50. There are three instruments, two multi and one wind, that behave exactly the same. I tried to run the firmware update again but the screen of the plotter no more shows the FI50 instruments. I have added a screenshot to better show how the instruments look after the upgrade.
Does anybody know how to fix the problem?
Best regards Axel