M
Mandarine
Guest
Are there any specific requirements for the Navpilot 700 to control the Mamba 1 HP 24VDC 25 A electric drivemotor with a 24 VDC 2 A clutch. The 700 was installed to replace the Robertson AP20.
The result is disappointing as the 700 does not recognize the clutch and will not always complete the dock side setup. Messages are : deadband to big or overload. Manyally setting the deadband results in overload messages. Sometimes the test will complete but when dodging the rudder runs to excessive angles and then suddenly wants to return which again creates an overload situation. Drive motor was taken out to check but is working fine.
The result is disappointing as the 700 does not recognize the clutch and will not always complete the dock side setup. Messages are : deadband to big or overload. Manyally setting the deadband results in overload messages. Sometimes the test will complete but when dodging the rudder runs to excessive angles and then suddenly wants to return which again creates an overload situation. Drive motor was taken out to check but is working fine.