Navpilot 711 monochrome, no data

ramatuska

Member
Boat equipment includes the 711, TZ2, Airmar N2K GPS/WX sensor.

No position, wind, speed data is seen on the 711, only heading and rudder. Data is seen on the TZ2 and the N2K display.

Controller software is V 1.14, Processor is V 1.23. Problem may have started after the software upgrade, not sure as I have not recently used the AP.

Nav data source give me the option of either the TZ2 or NMEA 20. I've tried singly and both with no change. Only the PG700 is seen in the sensor in use list.
 
Go into the install mode of the pilot (Hold Menu and immediately knob quickly three time)
Go to CAN BUS SETUP, then select "Incoming Can bus data".
What are the PGN numbers highlighted dark shown?
 
PGNs were there, see attached. But device selection was not correct.

Made corrections, all is good.

Thank you again.

PS: why did Furuno make updates to the Navpilot so difficult. Processor is already connected via NMEA2000 and most Furuno installations have Ethernet hub. They could have at least used an external USB port. My processor unit is buried in a cabinet. :D
 
Back
Top