RD-33 Not showing temp

[Moonzy1]

I have a TZT2 MFD setup and and sending data to the RD33 thru N2K.

I previously had the RD33 working correctly but now I cannot get temp to come up in the RD33.

All other data shows.

Ive checked source and pgn output from
MDF and all is correct

Ive reset the RD33 and made sure it see the MFD for temp.

Checked the N2k Spine
Swapped N2k cables

The RD33 sees the correct equipment even in the I/O setup window for Temp. Just no data output in the temp field

stumped on this one

 

[Johnny Electron]

A common mistake is selecting the "temperature" PGN to go out. I hate they didn't provide more description because that is for Air Temp. I suspect that this might be the cause. You must turn on the Environmental Perimeters PGN to send over water temp.

 

[Moonzy1]

Ok Leme give that a try
thx

 

[Moonzy1]

You were right

All set

Thank you

 

[Johnny Electron]

:jump :jump